You could nearly fit 2 bottles of Single Malt Whiskey side by side in something like that
Bill's 16.49-3 OB
- Thread starter Billrw136
- Start date
You could nearly fit 2 bottles of Single Malt Whiskey side by side in something like that
I am fortunate in having two large garages - I describe them as organised chaos!!
.
Perhaps if Jayco had installed the sinks in these with the bowl to the right then a drawer would have been possible??
Looks good Bill , I have a question, how did you go about getting a matching finish on the draw front.
Terry
Terry
That's right Bill but it makes it more awkward to do the dishes ( have to reach further) because the drain board would be on the left then. We had a van where we had to reach into a corner and didnt like it.
While installing heater I had to remove a panel from between the seats that covers the wiring - not easy - it was installed and fastened before the side wall went on - impossible to remove without damaging/destroying it.
HENCE - the following - new timber panel made up from pine - this will be removable. Photos show it sitting in position - not fixed yet.
While I was at it I installed an LED light over the table.......on....
......off..........
HENCE - the following - new timber panel made up from pine - this will be removable. Photos show it sitting in position - not fixed yet.
While I was at it I installed an LED light over the table.......on....
......off..........
Nice work Bill. I had to fit a light over our table as well so I used the one supplied as the plug in extension over the bed.
Thanks for the kind comments - now for this weekend's job......when we purchased our Expanda it came with a microwave - we very seldom use a microwave, so we gave it to some young family friends who were just moving out of home. This meant we were left with a space above our fridge - initially we just put jackets etc in there.
I have now made a drawer to go there using the drawer hardware from the drawer we lost when I installed the Truma gas heater. This new drawer will be used as a grocery/pantry drawer.
I had to pack out the sides of the space - photo below shows what I did.........
The drawer without its front.......
Another view of spacer section showing drawer runner in place and aluminium angle on the bottom edge to attach to base of space........
The space into which this will go.........
This shows the side spacers in situ......
Drawer (with no front) in position..........
Ditto.......
MDF front on (I will paint this - not sure what colour yet)......
I also replaced the hot water anode this weekend - see photo below......it's interesting how little was left after 18 months and probably only 2 week of use!!
Bill
I have now made a drawer to go there using the drawer hardware from the drawer we lost when I installed the Truma gas heater. This new drawer will be used as a grocery/pantry drawer.
I had to pack out the sides of the space - photo below shows what I did.........
The drawer without its front.......
Another view of spacer section showing drawer runner in place and aluminium angle on the bottom edge to attach to base of space........
The space into which this will go.........
This shows the side spacers in situ......
Drawer (with no front) in position..........
Ditto.......
MDF front on (I will paint this - not sure what colour yet)......
I also replaced the hot water anode this weekend - see photo below......it's interesting how little was left after 18 months and probably only 2 week of use!!
Bill
Nice work there Bill, HHHHMMMM me thinks it might be time for me to replace my anode again, Only done it once and the vans almost 3 yrs old with fairly regular use
