Looking for ideas for how to neatly mount this DigOptions camera onto my Jayco 20.64-1 Expanda. Reference picture of 20.64-1 rear attached.
Ideally, it needs to be above the rear bed and (preferably) in the centre - although folk may have other opinions
Here are things I've thought of:
Overall, I want this to be a neat installation, so any suggests are welcome. This site is full of smart people with ingenious and clever ideas...
Ideally, it needs to be above the rear bed and (preferably) in the centre - although folk may have other opinions
Here are things I've thought of:
- Bolt camera directly onto van under high level stop light and drown in silicon. This is my 'last resort' option. Practical, but looks ugly (and triggers my 'neat-freak' OCD!)
- Replace LED stop-light with this unit from SVS and mount camera on that. Nice solution, but centre bracket is too narrow for dual cam. Maybe adapt the SVS light?
- Replace LED stop-light with two shorter LED's and mount camera(s) between the two LED's
- Install a housing like this and mount a (black) camera inside. Problem: housing is designed for Furrion camera, but it may fit my dual cam
- Going for a completely different camera (this one is great, but not shipped/supported outside UK). Problem: I've already ordered the DigOptions camera.
- Make a 'T' bracket that will sandwich between the high level stop light and the van, but extend down so that I can mount the dual-cam on that.
Overall, I want this to be a neat installation, so any suggests are welcome. This site is full of smart people with ingenious and clever ideas...