High pressure inlet

[Swerve]

OK last trip my my high pressure inlet was leaking on the inside at the JG fitting.

Guessing to fix it I need to pull it apart, re-seat it and also ad those red locking clips.

Any tips, where can I buy the red clips ?

Thanks Steve

 

[Pace]

Has been done before and a member has written up the fix. Search for it on the forum, should find it. Cheers Pace.

 

[Swerve]

Pace, thanks for your response but I did search under a few varieties "High Pressure Inlet "" Water Leak" and some more with no luck. I am a admin on another forum and yes when you have been a member for a long time you see the same questions over and over. Yes it is easy to say "hey go and search". But when I have a newbie ask a question and I normally try and find the thread for them. I quite often have trouble finding it myself. So I have searched with no luck, thanks for your help.

 

[Pace]

Pace, thanks for your response but I did search under a few varieties "High Pressure Inlet "" Water Leak" and some more with no luck. I am a admin on another forum and yes when you have been a member for a long time you see the same questions over and over. Yes it is easy to say "hey go and search". But when I have a newbie ask a question and I normally try and find the thread for them. I quite often have trouble finding it myself. So I have searched with no luck, thanks for your help.

Found it (I think), look through this. Pace.

http://www.expandasdownunder.com/threads/water-inlet-leaking.5131/#post-76056

 

[macca]

If the JG fitting is leaking where the tube goes into the fitting, it could be because the pipe has a scratch on it. You can normally feel it or see it. If it is scratched the O ring will not seal and you will need a new bit of pipe. The leak might be where they join 2 fittings together. You can nip it up and the tube should turn whilst you are doing it. With plastic fittings they use, don't go too heavy handed with it.
http://www.rvpartsexpress.com.au/plumbing-bathroom/john-guest-plumbing-equipment.html