Hello,
Whilst on my recent trip, 2 out of the 4 electric wires going to the brakes broke. I twisted them together and taped up as a temporary measure, but they broke less than 1cm from the wheel so there is not much wire to join them together.
I was thinking of taking the wheel off and re-joining the wire inside the wheel.
I am after some advice as to what is involved in taking the wheel / hub (I think it is called) to repair.
I have no worries in removing the wheel and also have a torque wrench to tighten them back to the correct torque.
Alternatively if I buy a cordless soldering iron, and some heat shrink, I could repair them that way too if easier.
I will post up a picture shortly.
Thanks in advance!
Whilst on my recent trip, 2 out of the 4 electric wires going to the brakes broke. I twisted them together and taped up as a temporary measure, but they broke less than 1cm from the wheel so there is not much wire to join them together.
I was thinking of taking the wheel off and re-joining the wire inside the wheel.
I am after some advice as to what is involved in taking the wheel / hub (I think it is called) to repair.
I have no worries in removing the wheel and also have a torque wrench to tighten them back to the correct torque.
Alternatively if I buy a cordless soldering iron, and some heat shrink, I could repair them that way too if easier.
I will post up a picture shortly.
Thanks in advance!