one question @glennhoen
did they fit
or were they slightly short (as per mine - Mk I version of the Jayco Covers.........
did they fit
or were they slightly short (as per mine - Mk I version of the Jayco Covers.........
Exterior Installing Jayco Storm Covers?
- Thread starter macca
- Start date
They seemed to fit, they hang an inch or two below the base of the bed end. I have only seen photos of them fitted though so will try to check out a few in the flesh to see how mine compare.
they are supposed to hang slightly lower than the bed base
I was meaning - do both ends touch the body at the same time...
mine are 10mm too short in length
I was meaning - do both ends touch the body at the same time...
mine are 10mm too short in length
Oh, sorry, yes no drama there. That would be disappointing- what did you do or do you just put up with them being short?
with mine, if you put in the press studs on one side, the other side just make it - but not enough to press them on
soooo
I had velcro sewn into the ends, and a piece fitted to the body
they neatly fit, and the velcro stops them from coming un done and flapping about
soooo
I had velcro sewn into the ends, and a piece fitted to the body
they neatly fit, and the velcro stops them from coming un done and flapping about
I've got one of he first lot they started selling - even CaravanLand over here in Perth did not know about them when I asked
I think the first lot was either 50 or 100
when they sold like hot cakes to a fat kid, they started to get more made - and better made
page 5, post 91 is the start of my fun with fitting, on my build page below
I think the first lot was either 50 or 100
when they sold like hot cakes to a fat kid, they started to get more made - and better made
page 5, post 91 is the start of my fun with fitting, on my build page below