Pole holders

[Grego]

Hi just got some PVC pipe to mount on the rear bar of my 09 outback expanda but looking at the brackets at camec they look like they are used on a square bumper bar and not a round one which I have just trying to find out where I could source this from.Thanks Grego

 

[chartrock]

I'm looking for the same thing. :yell:

 

[cruza driver]

I have seen them mounted on the rear but unfortunately I didnt look at the mounts, I wish I had of though

 

[drewy]

There might be a plumbers type clamp available that will clamp to the bumper, try a plumbing supply.

 

[mfexpanda]

Hi just got some PVC pipe to mount on the rear bar of my 09 outback expanda but looking at the brackets at camec they look like they are used on a square bumper bar and not a round one which I have just trying to find out where I could source this from.Thanks Grego

I got rid of the round bumper I hated it . I cant use the words I used when I first saw it on my outback expanda

 

[chartrock]

I managed to fit a 100mm tube to the rear bar before leaving home, It has now done over 3000Km and is still sitting tight.

 

[Grego]

Thanks did much the same also put a 90mm up the front above chasiss for a couple of tent poles.Grego

 

[boots33]

I managed to fit a 100mm tube to the rear bar before leaving home, It has now done over 3000Km and is still sitting tight.

Looks nice and sturdy Paul did you custom make the latch for the end cap?

 

[cruza driver]

Looks like a great solution Chartrock

 

[chartrock]

Looks nice and sturdy Paul did you custom make the latch for the end cap?

No Boots. It is just a 50mm hasp from Bunnings and I bent the loop around the end cap. It was a tight fit but it just makes it nicely and is currently "locked" with a tie wrap. :music: