Interior Canvas bed ends

Crainy

New Member
Feb 19, 2018
1
0
1
Wickham
G'day.
Just had the flyscreens re-done on the canvas bed ends of my 2005 outback expanda.Any tips for getting them back on ?
I've tried spraying silicon spray in the channel and then sliding the canvas into the channel,but i'm only getting about halfway before it gets to hard to pull through anymore
 

Crusty181

Well-Known Member
Feb 7, 2010
6,854
13,971
113
Mentone, VIC
If the channel in the older models is the same as later models, and we're talking about the top edge of the tent section, I pushed it into the channel not slid it. Dont use anything that will remain slippery such as silicone sprays or oil based stuff because you run the risk of it deciding to come out by itself later. If you need something to help a weak dish washing mix will at least dry off over time. Good luck