My awning has perished on each end of the material so was looking to change the material on my awning until I realised I had also broken the unroll/roll up switch on the end of the barrel. So upon this discovery I decided to replace the whole awning, barrel and all. This brought me to my next dilemma as I have the Carefree Awning with the LED strip included. I have since purchased the correct replacement with the same LED set up, but I am looking for advice from anyone here on where the wiring runs that is already set up on the awning, so that I can connect straight into it. Do I need to trace the wire to run the new cable inside, or should I just cut and join the new wire on outside the van solder them up and be happy with that?
Any advice greatly appreciated.
Thanks Ben
Any advice greatly appreciated.
Thanks Ben